kernel: accepting plaintext data frames in protected networks

An issue was discovered in the ALFA Windows 10 driver 6.1316.1209 for AWUS036H. The WEP, WPA, WPA2, and WPA3 implementations accept plaintext frames in a protected Wi-Fi network. An adversary can abuse this to inject arbitrary data frames independent of the network configuration.

kernel: not verifying TKIP MIC of fragmented frames

An issue was discovered in the ALFA Windows 10 driver 6.1316.1209 for AWUS036H. The Wi-Fi implementation does not verify the Message Integrity Check (authenticity) of fragmented TKIP frames. An adversary can abuse this to inject and possibly decrypt packets in WPA or WPA2 networks that support the TKIP data-confidentiality protocol.

kernel: Forwarding EAPOL from unauthenticated wifi client

An issue was discovered in the kernel in NetBSD 7.1. An Access Point (AP) forwards EAPOL frames to other clients even though the sender has not yet successfully authenticated to the AP. This might be abused in projected Wi-Fi networks to launch denial-of-service attacks against connected clients and makes it easier to exploit other vulnerabilities in connected clients.

kernel: wifi frame payload being parsed incorrectly as an L2 frame

The 802.11 standard that underpins Wi-Fi Protected Access (WPA, WPA2, and WPA3) and Wired Equivalent Privacy (WEP) doesn't require that the A-MSDU flag in the plaintext QoS header field is authenticated. Against devices that support receiving non-SSP A-MSDU frames (which is mandatory as part of 802.11n), an adversary can abuse this to inject arbitrary network packets.

A vulnerability in the Cisco AnyConnect VPN server of Cisco Meraki MX and Cisco Meraki Z Series Teleworker Gateway devices could allow an unauthenticated, remote attacker to cause a DoS condition for targeted users of the AnyConnect service on an affected device. This vulnerability is due to insufficient entropy for handlers that are used during SSL VPN session establishment. An unauthenticated attacker could exploit this vulnerability by brute forcing valid session handlers. An authenticated attacker could exploit this vulnerability by connecting to the AnyConnect VPN service of an affected device to retrieve a valid session handler and, based on that handler, predict further valid session handlers. The attacker would then send a crafted HTTPS request using the brute-forced or predicted session handler to the AnyConnect VPN server of the device. A successful exploit could allow the attacker to terminate targeted SSL VPN sessions, forcing remote users to initiate new VPN connections and reauthenticate.

A vulnerability in the Cisco AnyConnect VPN server of Cisco Meraki MX and Cisco Meraki Z Series Teleworker Gateway devices could allow an unauthenticated, remote attacker to hijack an AnyConnect VPN session or cause a denial of service (DoS) condition for individual users of the AnyConnect VPN service on an affected device. This vulnerability is due to weak entropy for handlers that are used during the VPN authentication process as well as a race condition that exists in the same process. An attacker could exploit this vulnerability by correctly guessing an authentication handler and then sending crafted HTTPS requests to an affected device. A successful exploit could allow the attacker to take over the AnyConnect VPN session from a target user or prevent the target user from establishing an AnyConnect VPN session with the affected device.

A vulnerability in the Cisco AnyConnect VPN server of Cisco Meraki MX and Cisco Meraki Z Series Teleworker Gateway devices could allow an unauthenticated, remote attacker to cause a DoS condition on an affected device. This vulnerability is due to insufficient resource management while establishing SSL VPN sessions. An attacker could exploit this vulnerability by sending a series of crafted HTTPS requests to the VPN server of an affected device. A successful exploit could allow the attacker to cause the Cisco AnyConnect VPN server to stop accepting new connections, preventing new SSL VPN connections from being established. Existing SSL VPN sessions are not impacted. Note: When the attack traffic stops, the Cisco AnyConnect VPN server recovers gracefully without requiring manual intervention.

Multiple vulnerabilities in the Cisco AnyConnect VPN server of Cisco Meraki MX and Cisco Meraki Z Series Teleworker Gateway devices could allow an unauthenticated, remote attacker to cause a DoS condition in the AnyConnect service on an affected device. These vulnerabilities are due to insufficient validation of client-supplied parameters while establishing an SSL VPN session. An attacker could exploit these vulnerabilities by sending a crafted HTTPS request to the VPN server of an affected device. A successful exploit could allow the attacker to cause the Cisco AnyConnect VPN server to restart, resulting in the failure of the established SSL VPN connections and forcing remote users to initiate a new VPN connection and reauthenticate. A sustained attack could prevent new SSL VPN connections from being established. Note: When the attack traffic stops, the Cisco AnyConnect VPN server recovers gracefully without requiring manual intervention.

A vulnerability in the Cisco AnyConnect VPN server of Cisco Meraki MX and Cisco Meraki Z Series Teleworker Gateway devices could allow an unauthenticated, remote attacker to cause a DoS condition in the AnyConnect service on an affected device. This vulnerability is due to insufficient resource management when establishing TLS/SSL sessions. An attacker could exploit this vulnerability by sending a series of crafted TLS/SSL messages to the VPN server of an affected device. A successful exploit could allow the attacker to cause the Cisco AnyConnect VPN server to stop accepting new connections, preventing new SSL VPN connections from being established. Existing SSL VPN sessions are not impacted. Note: When the attack traffic stops, the Cisco AnyConnect VPN server recovers gracefully without requiring manual intervention.

Multiple vulnerabilities in the Cisco AnyConnect VPN server of Cisco Meraki MX and Cisco Meraki Z Series Teleworker Gateway devices could allow an unauthenticated, remote attacker to cause a DoS condition in the AnyConnect service on an affected device. These vulnerabilities are due to insufficient validation of client-supplied parameters while establishing an SSL VPN session. An attacker could exploit these vulnerabilities by sending a crafted HTTPS request to the VPN server of an affected device. A successful exploit could allow the attacker to cause the Cisco AnyConnect VPN server to restart, resulting in the failure of the established SSL VPN connections and forcing remote users to initiate a new VPN connection and reauthenticate. A sustained attack could prevent new SSL VPN connections from being established. Note: When the attack traffic stops, the Cisco AnyConnect VPN server recovers gracefully without requiring manual intervention.

Cisco Meraki MX and Z3 Teleworker Gateway AnyConnect VPN Denial of Service Vulnerability

Multiple vulnerabilities in the Cisco AnyConnect VPN server of Cisco Meraki MX and Cisco Meraki Z Series Teleworker Gateway devices could allow an unauthenticated, remote attacker to cause a DoS condition in the AnyConnect service on an affected device. These vulnerabilities are due to insufficient validation of client-supplied parameters while establishing an SSL VPN session. An attacker could exploit these vulnerabilities by sending a crafted HTTPS request to the VPN server of an affected device. A successful exploit could allow the attacker to cause the Cisco AnyConnect VPN server to restart, resulting in the failure of the established SSL VPN connections and forcing remote users to initiate a new VPN connection and reauthenticate. A sustained attack could prevent new SSL VPN connections from being established. Note: When the attack traffic stops, the Cisco AnyConnect VPN server recovers gracefully without requiring manual intervention.

Cisco Meraki MX and Z3 Teleworker Gateway VPN Denial of Service Vulnerability

A vulnerability in the Cisco AnyConnect VPN server of Cisco Meraki MX and Cisco Meraki Z3 Teleworker Gateway devices could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient validation of client-supplied parameters while establishing an SSL VPN session. An attacker could exploit this vulnerability by crafting a malicious request and sending it to the affected device. A successful exploit could allow the attacker to cause the Cisco AnyConnect VPN server to crash and restart, resulting in the failure of the established SSL VPN connections and forcing remote users to initiate a new VPN connection and re-authenticate. A sustained attack could prevent new SSL VPN connections from being established. Note: When the attack traffic stops, the Cisco AnyConnect VPN server recovers gracefully without requiring manual intervention. Cisco Meraki has released software updates that address this vulnerability.

kernel: Reassembling fragments encrypted under different keys

The 802.11 standard that underpins Wi-Fi Protected Access (WPA, WPA2, and WPA3) and Wired Equivalent Privacy (WEP) doesn't require that all fragments of a frame are encrypted under the same key. An adversary can abuse this to decrypt selected fragments when another device sends fragmented frames and the WEP, CCMP, or GCMP encryption key is periodically renewed.