A vulnerability in the IPv6 Router Advertisement (RA) packet processing of Cisco Access Point Software could allow an unauthenticated, adjacent attacker to modify the IPv6 gateway on an affected device. This vulnerability is due to a logic error in the processing of IPv6 RA packets that are received from wireless clients. An attacker could exploit this vulnerability by associating to a wireless network and sending a series of crafted IPv6 RA packets. A successful exploit could allow the attacker to temporarily change the IPv6 gateway of an affected device. This could also lead to intermittent packet loss for any wireless clients that are associated with the affected device.

A vulnerability in the Layer 2 Ethernet services of Cisco IOS XR Software could allow an unauthenticated, adjacent attacker to cause the line card network processor to reset, resulting in a denial of service (DoS) condition. This vulnerability is due to the incorrect handling of specific Ethernet frames that are received on line cards that have the Layer 2 services feature enabled. An attacker could exploit this vulnerability by sending specific Ethernet frames through an affected device. A successful exploit could allow the attacker to cause the ingress interface network processor to reset, resulting in a loss of traffic over the interfaces that are supported by the network processor. Multiple resets of the network processor would cause the line card to reset, resulting in a DoS condition.

A vulnerability in the access control list (ACL) processing on MPLS interfaces in the ingress direction of Cisco IOS XR Software could allow an unauthenticated, remote attacker to bypass a configured ACL. This vulnerability is due to improper assignment of lookup keys to internal interface contexts. An attacker could exploit this vulnerability by attempting to send traffic through an affected device. A successful exploit could allow the attacker to access resources behind the affected device that were supposed to be protected by a configured ACL.

A vulnerability in the CLI of the Cisco Integrated Management Controller (IMC) could allow an authenticated, local attacker to perform command injection attacks on the underlying operating system and elevate privileges to root. To exploit this vulnerability, the attacker must have read-only or higher privileges on an affected device. This vulnerability is due to insufficient validation of user-supplied input. An attacker could exploit this vulnerability by submitting a crafted CLI command. A successful exploit could allow the attacker to elevate privileges to root.

Cisco Unified Communications Manager Stored Cross-Site Scripting Vulnerability

A vulnerability in the web-based management interface of Cisco Unified Communications Manager (Unified CM) and Cisco Unified Communications Manager Session Management Edition (Unified CM SME) could allow an authenticated, remote attacker to conduct a cross-site scripting (XSS) attack against a user of the interface. This vulnerability exists because the web-based management interface does not properly validate user-supplied input. An attacker could exploit this vulnerability by injecting malicious code into specific pages of the interface. A successful exploit could allow the attacker to execute arbitrary script code in the context of the affected interface or access sensitive, browser-based information. To exploit this vulnerability, the attacker must have valid administrative credentials.

A vulnerability in the DHCP version 4 (DHCPv4) server feature of Cisco IOS XR Software could allow an unauthenticated, remote attacker to trigger a crash of the dhcpd process, resulting in a denial of service (DoS) condition. This vulnerability exists because certain DHCPv4 messages are improperly validated when they are processed by an affected device. An attacker could exploit this vulnerability by sending a malformed DHCPv4 message to an affected device. A successful exploit could allow the attacker to cause a crash of the dhcpd process. While the dhcpd process is restarting, which may take approximately two minutes, DHCPv4 server services are unavailable on the affected device. This could temporarily prevent network access to clients that join the network during that time period and rely on the DHCPv4 server of the affected device. Notes: Only the dhcpd process crashes and eventually restarts automatically. The router does not reload. This vulnerability only applies to DHCPv4. DHCP version 6 (DHCPv6) is not affected.

A vulnerability in the boot process of Cisco Access Point (AP) Software could allow an unauthenticated, physical attacker to bypass the Cisco Secure Boot functionality and load a software image that has been tampered with on an affected device. This vulnerability exists because unnecessary commands are available during boot time at the physical console. An attacker could exploit this vulnerability by interrupting the boot process and executing specific commands to bypass the Cisco Secure Boot validation checks and load an image that has been tampered with. This image would have been previously downloaded onto the targeted device. A successful exploit could allow the attacker to load the image once. The Cisco Secure Boot functionality is not permanently compromised.

A vulnerability in the Secure Copy Protocol (SCP) and SFTP feature of Cisco IOS XR Software could allow an authenticated, local attacker to create or overwrite files in a system directory, which could lead to a denial of service (DoS) condition. The attacker would require valid user credentials to perform this attack. This vulnerability is due to a lack of proper validation of SCP and SFTP CLI input parameters. An attacker could exploit this vulnerability by authenticating to the device and issuing SCP or SFTP CLI commands with specific parameters. A successful exploit could allow the attacker to impact the functionality of the device, which could lead to a DoS condition. The device may need to be manually rebooted to recover. Note: This vulnerability is exploitable only when a local user invokes SCP or SFTP commands at the Cisco IOS XR CLI. A local user with administrative privileges could exploit this vulnerability remotely.

Tinycontrol LAN Controller v3 (LK3) Remote DoS

Tinycontrol LAN Controller v3 (LK3) firmware versions up to 1.58a (hardware v3.8) contain a missing authentication vulnerability in the stm.cgi endpoint. A remote, unauthenticated attacker can send crafted requests to forcibly reboot the device or restore factory settings, leading to a denial of service and configuration loss.

A vulnerability in the Device Analytics action frame processing of Cisco Wireless Access Point (AP) Software could allow an unauthenticated, adjacent attacker to inject wireless 802.11 action frames with arbitrary information. This vulnerability is due to insufficient verification checks of incoming 802.11 action frames. An attacker could exploit this vulnerability by sending 802.11 Device Analytics action frames with arbitrary parameters. A successful exploit could allow the attacker to inject Device Analytics action frames with arbitrary information, which could modify the Device Analytics data of valid wireless clients that are connected to the same wireless controller.

Multiple Cisco Products Snort 3 MIME Denial of Service Vulnerability

Multiple Cisco products are affected by a vulnerability in the Snort 3 HTTP Decoder that could allow an unauthenticated, remote attacker to cause the Snort 3 Detection Engine to restart. This vulnerability is due to a lack of complete error checking when the MIME fields of the HTTP header are parsed. An attacker could exploit this vulnerability by sending crafted HTTP packets through an established connection to be parsed by Snort 3. A successful exploit could allow the attacker to cause a DoS condition when the Snort 3 Detection Engine unexpectedly restarts.

Cisco BroadWorks Network Server TCP Denial of Service Vulnerability

A vulnerability in the local interface of Cisco BroadWorks Network Server could allow an unauthenticated, remote attacker to exhaust system resources, causing a denial of service (DoS) condition. This vulnerability exists because rate limiting does not occur for certain incoming TCP connections. An attacker could exploit this vulnerability by sending a high rate of TCP connections to the server. A successful exploit could allow the attacker to cause TCP connection resources to grow rapidly until the Cisco BroadWorks Network Server becomes unusable. Note: To recover from this vulnerability, either Cisco BroadWorks Network Server software must be restarted or the Cisco BroadWorks Network Server node must be rebooted. For more information, see the section of this advisory. Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability.

Cisco ATA 190 Series Analog Telephone Adapter firmware Cisco Discovery Protocol Denial of Service Vulnerability

A vulnerability in the Cisco Discovery Protocol functionality of Cisco ATA 190 Series Adaptive Telephone Adapter firmware could allow an unauthenticated, remote attacker to cause a DoS condition on an affected device. This vulnerability is due to an out-of-bounds read when processing Cisco Discovery Protocol packets. An attacker could exploit this vulnerability by sending crafted Cisco Discovery Protocol packets to an affected device. A successful exploit could allow the attacker to cause a service restart.Cisco has released firmware updates that address this vulnerability. There are no workarounds that address this vulnerability.

kernel: not verifying TKIP MIC of fragmented frames

An issue was discovered in the ALFA Windows 10 driver 6.1316.1209 for AWUS036H. The Wi-Fi implementation does not verify the Message Integrity Check (authenticity) of fragmented TKIP frames. An adversary can abuse this to inject and possibly decrypt packets in WPA or WPA2 networks that support the TKIP data-confidentiality protocol.

kernel: Forwarding EAPOL from unauthenticated wifi client

An issue was discovered in the kernel in NetBSD 7.1. An Access Point (AP) forwards EAPOL frames to other clients even though the sender has not yet successfully authenticated to the AP. This might be abused in projected Wi-Fi networks to launch denial-of-service attacks against connected clients and makes it easier to exploit other vulnerabilities in connected clients.

kernel: wifi frame payload being parsed incorrectly as an L2 frame

The 802.11 standard that underpins Wi-Fi Protected Access (WPA, WPA2, and WPA3) and Wired Equivalent Privacy (WEP) doesn't require that the A-MSDU flag in the plaintext QoS header field is authenticated. Against devices that support receiving non-SSP A-MSDU frames (which is mandatory as part of 802.11n), an adversary can abuse this to inject arbitrary network packets.

Cisco Nexus Dashboard Server Side Request Forgery Vulnerability

A vulnerability in Cisco Nexus Dashboard and Cisco Nexus Dashboard Insights could allow an unauthenticated, remote attacker to conduct a server-side request forgery (SSRF) attack through an affected device. This vulnerability is due to improper input validation for specific HTTP requests. An attacker could exploit this vulnerability by persuading an authenticated user of the device management interface to click a crafted link. A successful exploit could allow the attacker to send arbitrary network requests that are sourced from the affected device to an attacker-controlled server. The attacker could then execute arbitrary script code in the context of the affected interface or access sensitive browser-based information.

Cisco Nexus Dashboard Insights Arbitrary File Write Vulnerability

A vulnerability in the Metadata update feature of Cisco Nexus Dashboard Insights could allow an authenticated, remote attacker to write arbitrary files to an affected system. This vulnerability is due to insufficient validation of the metadata update file. An attacker could exploit this vulnerability by crafting a metadata update file and manually uploading it to an affected device. A successful exploit could allow the attacker to write arbitrary files to the underlying operating system as the root user. To exploit this vulnerability, the attacker must have valid administrative credentials. Note: Manual uploading of metadata files is typical for Air-Gap environments but not for Cisco Intersight Cloud connected devices. However, the manual upload option exists for both deployments.

Cisco Smart Software Manager On-Prem Arbitrary Command Execution Vulnerability

A vulnerability in Cisco Smart Software Manager On-Prem (SSM On-Prem) could allow an unauthenticated, remote attacker to execute arbitrary commands on the underlying operating system of an affected SSM On-Prem host. This vulnerability is due to the unintentional exposure of an internal service. An attacker could exploit this vulnerability by sending a crafted request to the API of the exposed service. A successful exploit could allow the attacker to execute commands on the underlying operating system with root-level privileges.

Cisco Nexus Dashboard Configuration REST API Unauthorized Access Vulnerability

A vulnerability in the configuration backup feature of Cisco Nexus Dashboard could allow an attacker who has the encryption password and access to Full or Config-only backup files to access sensitive information. This vulnerability exists because authentication details are included in the encrypted backup files. An attacker with a valid backup file and encryption password from an affected device could decrypt the backup file. The attacker could then use the authentication details in the backup file to access internal-only APIs on the affected device. A successful exploit could allow the attacker to execute arbitrary commands on the underlying operating system as the root user.